Guide To Learn
The various fixtures used are: The most commonly used type of hinges is the butt hinge whose length varies from 1 to 20 cm. Various other types of hinges like counter flap hinges, spring hinges and parliamentary hinges are also being used. Barrel bolts and tower bolts are the most commonly used type and their […]
Windows are provided in the wall openings for admission of light, free circulation of air and sunshine. As a general rule, the minimum area of a window or windows should be one-tenth of the floor area of the room and at least half of this area should be made open for ventilation. 17.5.1 Casement window […]
The doors commonly used in buildings are classified into various types depending upon several factors or aspects like materials used in the manufacture of doors, arrangement of door components, method of construction and their working operation. 17.4.1 Battened and ledged door This is the simplest form of door, which is frequently used for narrow openings. […]
17.3.1 Fixed window It is fixed in the wall and makes no provision for natural air circulation. 17.3.2 Double hung window In this type, both sashes slide vertically with the weight balanced by the sash weight, spiral springs or tape spring balances. 17.3.3 Horizontal sliding window In this type, either one or both sashes are […]
From the operational point of view, the doors are classified as below. 17.2.1 Swinging doors In these doors, the shutter is hung to the door frame on hinges or butts fixed to one side of the shutter, so that they swing on a vertical axis. The doors may be single swinging, double swinging or double […]
The designer or planner should observe the following rules while deciding the location of doors and windows:
When concrete is placed, it is in plastic state. It requires to be supported by temporary supports and casings of the desired shape till it becomes sufficiently strong to support its own weight. This temporary casing is known as the formwork. 16.11.1 Requirements of a good formwork 16.11.2 Steel formwork Steel is used for formwork […]
Concrete derives its strength by the hydration of cement particles. The quality of the product of hydration and consequently the amount of gel formed depend on the extent of hydration. Theoretically, water–cement ratio of 0.38 is required to hydrate all the particles of the cement and to occupy the space in the gel pores. In […]
Compaction of concrete is the method adopted for expelling the entrapped air from the concrete. If the air is not removed fully, the concrete loses strength considerably. Figure 16.3 shows the relation between loss of strength and air voids left due to lack of compaction. It can be seen from Figure 16.3 that 5 per cent voids reduce the […]
Soon after mixing, the concrete has to be transported and placed in the moulds. A maximum time limit of 1½ hours is allowed between the moment of actual mixing and placing of concrete. It should never be disturbed once the setting has commenced. While transporting and placing of concrete, care should be taken to avoid […]